Results 1 to 2 of 2

Thread: Pipe flare (AGS/AN)

  1. #1

    Default Pipe flare (AGS/AN)

    Hey chaps,

    following on from this thread http://www.airmech.co.uk/forums/show...ight=pipe+flre

    Included angle of American is 74degress
    Included angle of British 32degrees

    My TTS notes don't mention actual angle, which in the attached thread is 37degrees? Is that for both American and British?

    Cheers,

    E

  2. #2
    Join Date
    Feb 2003
    Location
    Suki yaki
    Posts
    8,794

    Default Re: Pipe flare (AGS/AN)

    In the pre-JAA/EASA days, things were clean cut when it came to specs.

    To prepare for UK/CAA exams, one would quote BCAR/CAIP data. To prepare for FAA exams, one would use FAR data. And they varied a lot, as in this case. Another one used to be the minimum number of threads to determine the safety of a turnbuckle or bolted joint.

    Then came along the FAA/JAA harmonisation exercise to sort of smooth the edges and narrow the differences.

    The UK/CAA now conducts EASA PArt 66 exams to EASA standards. Would the UK/CAA be insisting on outdated AGS specs today?

    I would go for the AN spec at 74 degrees included.
    I love this job

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

Similar Threads

  1. Pipe Flare Angle
    By jpoth06 in forum Engineering Theory Questions
    Replies: 10
    Last Post: October 17th, 2009, 13:28
  2. Pipe ident tape
    By fenestron in forum Tools and Equipment
    Replies: 4
    Last Post: May 27th, 2005, 18:12
  3. PIPE BENDING / PIPE FLARING TOOLS - SUPPLIER
    By Turbro Prop in forum Tools and Equipment
    Replies: 5
    Last Post: March 22nd, 2005, 09:08

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •